LML CP3 Conversion Kit

Improve your LML Duramax's reliability and fueling capability with a CP3 conversion. Since its introduction, the CP4 has proven to be less reliable and less capable than the CP3 used in previous Duramax platforms.  Failures of the CP4 are extremely costly and require replacement of the entire fuel system. Avoid a costly failure down the road and convert your CP4 to a CP3 with our complete, no tuning required kit for the 2011-2016 LML Duramax platform.

What LML CP3 Conversion Kit is right for you?

“No Pump" Kit

This LML CP3 conversion gives you the option to select your own CP3 pump for your application.  This kit provides you with all of the hardware you need to adapt a LBZ/LMM based Bosch CP3 to your 2011-2016 LML Duramax.

"With Pump" Kit

This LML CP3 conversion gives you a brand new LBZ/LMM Bosch CP3 along with all of the hardware you need to convert your CP4 equipped Duramax to a CP3.  This kit is designed for use with or without a low pressure lift pump. For optimal performance, if the truck is equipped with a lift pump, the feed pressure to the CP3 should not exceed 5-6 psi when utilizing this kit.

Heavy Duty Kit 
This LML CP3 conversion features a brand new LBZ/LMM Bosch CP3 equipped with a Fleece Performance 10mm stroker cam along with all of the hardware you need to convert your CP4 equipped Duramax to a CP3.  This kit is designed for use with or without a low pressure lift pump. For optimal performance, if the truck is equipped with a lift pump, the feed pressure to the CP3 should not exceed 2 psi. Engine surging may be induced by the additional fuel pressure of a lift pump operating at pressures over 2 psi. If you are intending to combine this kit with a Fleece PowerFlo lift pump, contact us for a lower rate spring for your pump to accommodate operation with this kit. For higher lift pump pressures, FCA table values will require adjustment.